[time-nuts] Lucent RFTG-m-XO

TheInfamousFlavio at hotmail.com TheInfamousFlavio at hotmail.com
Tue Feb 6 22:59:23 EST 2007


I had the exact same problem as yours.  I discoverd that my 106B had a 
6-channel board in it vs. the 8-channel that is supposed to be in there.
I put a 8-channel board in and the fault and GPS lights went out.


----- Original Message ----- 
From: "Robert E. Martinson" <REMartinson at rcn.com>
To: "'Discussion of precise time and frequency measurement'" 
<time-nuts at febo.com>
Sent: Tuesday, February 06, 2007 11:27
Subject: Re: [time-nuts] Lucent RFTG-m-XO


> Over the weekend I left the XO unit running for 38 hours, with it 
> installed
> in its "house"  (No probing).  The GPS receiver was tracking satellites at
> the start and also at the end of the run as verified by monitoring J5-2
> w/VisualGPS.  The Fault & No GPS LEDs never went out.  I'm about to 
> conclude
> that I have a defective unit and will order another unless anyone has any
> further suggestions (PLEASE)?
>
>
> I see at least John A., Jim M., & Phil S. have working XO units.  I have
> just reviewed all the emails on the RFTG units and believe I have tried 
> all
> the previous suggestions.  Any additional secrets to share???
>
>
> Bob Martinson, N1VQR
>
>
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Phil Staton
> Sent: Thursday, February 01, 2007 6:53 PM
> To: time-nuts at febo.com
> Subject: [time-nuts] Lucent RFTG-m-XO
>
>
> Briefly:
> Leave it running for at least 24hrs.
> The 15MHz will slowly get on freq.
> Countup is available on 1pps socket.
> more when I have time
>
> _______________________________________________
> time-nuts mailing list
> time-nuts at febo.com
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>
> _______________________________________________
> time-nuts mailing list
> time-nuts at febo.com
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> 




More information about the time-nuts mailing list