[time-nuts] Looking for a Efratom FRS-C connector
Robert Darlington
rdarlington at gmail.com
Fri Oct 10 14:06:44 UTC 2008
Hi Mike,
I ordered the shell, that was easy enough to find once I had a good part
number. I wasn't sure on the coax connector so I bought one of each. I
have a roll of some skinny coax which I believe is RG174, but wasn't
positive. Instead of driving into work to check, I opted to just buy the
other type of connector. Also, not knowing what gender, I had to buy one of
each. The oscillator is still in transit and not on my desk to examine.
Thank you to all that responded. I appreciate the knowledge base and hope I
can reciprocate some day.
-Bob
On Wed, Oct 8, 2008 at 4:42 PM, Mike S <mikes at flatsurface.com> wrote:
> At 06:11 PM 10/8/2008, Robert Darlington wrote...
> >Hello all,
> >
> >Would any of you happen to know where I can find a mating connector
> >for the
> >Efratom FRS-C rubidium standard? I see one eBay ad via a Google
> >search
> >listing it as a "Cannon P/N DAM11WIS", but searches on the ITT/Cannon
> >website don't turn up any hits. Is this a valid part number?
>
> FCT makes them, and they're available from Mouser.
>
> Here's the catalog page: http://www.mouser.com/catalog/635/1223.pdf
>
> Mouser P/Ns: 152-FM11W1S-K121 (connector shell), 152-FMX006P102 (50 ohm
> crimp/solder coax contact for RG-174U sized cable)
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the time-nuts
mailing list