[time-nuts] femtosecond jitter anyone?
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Thu Apr 9 00:50:33 UTC 2009
Chris Mack / N1SKY wrote:
> On Apr 8, 2009, at 8:02 PM, Bruce Griffiths wrote:
>
>
>
>> Unless you are prepared to place the crystals in an oven with the
>> temperature regulated tightly and carefully tune the filter
>> periodically
>> then using a crystal filter (or any passive filter with a sufficiently
>> narrow bandwidth to cleanup the skirts) will not be particularly
>> useful.
>> It would be much easier to use a low bandwidth analog PLL with a low
>> noise VCXO to cleanup the 38.88MHz signal.
>>
>>
>
> http://www.national.com/pf/LM/LMK04000B.html
>
> Their app note uses a very low noise VCXO... The simulator software
> gets pretty close...
>
> Cheers,
> -chris
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
Chris
If you divide the output down to ~38MHz using a noiseless divider then
the performance is 20dB or more worse than can be achieved with a good
~38MHz crystal oscillator.
This seems to be a complex method of degrading the performance over that
possible with a simpler design.
Bruce
More information about the time-nuts
mailing list