[time-nuts] FE5680 Frequency adjustment voltage range

Don Latham djl at montana.com
Wed Feb 17 18:28:52 UTC 2010


It may be that shifting the voltage will mess up the calibration constant
in the synthesizer?
Don

Raj
> Angus informed that the two buttons are for shifting the freq. up or down,
> after one single "click" the adjustment range is around the center.
>
>
>>Suspect thats adjusting the c field. Would not hurt especially if the
>> unit
>>was used/surplus.
>>Try 4000.
>>
>>On Mon, Feb 15, 2010 at 12:44 AM, Raj <vu2zap at gmail.com> wrote:
>>
>>>
>>>        In my FE5680, I find that the trimpot for frequency adjust at
>>> one
>>> end 4.4V. The upper and lower voltages are 4.4 and 5.2 approx.
>>>
>>>        Does this mean it is at the end of its life?
>>>
>>>        There is a 4750 Resistor connected to the low end of the trimpot
>>> whose value can be reduced as a solution. Any experiences?
>
> --
> Raj, VU2ZAP
> Bangalore, India.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>


-- 
Dr. Don Latham AJ7LL
Six Mile Systems LLP
17850 Six Mile Road
POB 134
Huson, MT, 59846
VOX 406-626-4304
www.lightningforensics.com
www.sixmilesystems.com




More information about the time-nuts mailing list