[time-nuts] Cycling of Peltier junction

Bruce Griffiths bruce.griffiths at xtra.co.nz
Thu Sep 9 21:53:27 UTC 2010


There is a reference to thermomechanical fatigue in Peltier devices with 
respect to the effect of peltier device ripple current on the longevity 
of the Peltier devices in the HP Journal article on an optical power meter.

Bruce

J. Forster wrote:
> Peltier devices have been used as temperature control elements for
> decades. I've never heard of fatigue failures, but, if I were designing a
> chamber as you suggest, I'd try to keep the temperature differential
> across the TE element under maybe 15 to 20F. The harder you push it, the
> greater the stress.
>
> Also, the heat pumping power falls dramatically as the delta-T increases
> and it's a situation of rapidly deminishing returns.
>
> I'd not worry much about ramping the drive.
>
> FWIW,
>
> -John
>
> ===============
>
>
>
>    
>> Does anybody know about using the same Peltier junction for both heating
>> and cooling?
>> I'm concerned about thermal/mechanical shock when changing the polarity
>> back-n-forth between hot and cold.  Maybe there needs to be a controlled
>> ramp, if so then how do I figure out the rate?
>>
>> Why:
>> I'm in the process of building a small environmental chamber for my home
>> lab. The volume is ~30 liter, target temp range of 0C to 60C.  For the
>> cooling side I am using water circulation (radiator, pump, reservoir&
>> water block) and Peltier junctions.  At first I was planning to have two
>> separate systems, one for heating and one for cooling, but then I got to
>> thinking that using just the water and Peltier could be used for both.  I
>> will be using a PID for temp control, and two TEC1-12726 Peltier Qcmax(w)=
>> ~240 $B"$(BT =0j
>>
>>
>> Regards,
>> Jerome
>> -----------------------------------------------------------------------------------
>> This email message is for the sole use of the intended recipient(s) and
>> may contain
>> confidential information.  Any unauthorized review, use, disclosure or
>> distribution
>> is prohibited.  If you are not the intended recipient, please contact the
>> sender by
>> reply email and destroy all copies of the original message.
>> -----------------------------------------------------------------------------------
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>>
>>      
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>    





More information about the time-nuts mailing list