[time-nuts] FE-5680A Results so far
smither at c-c-i.com
Wed Dec 28 20:07:55 UTC 2011
Chuck Forsberg WA7KGX N2469R wrote:
> I haven't checked it, but the FE5680A has 1pps on pin 6.
> There is no documented way to sync the FE5680A 1pps to an external
> You could set an extreme value in the freq offset and wait for the 1pps
> to drift
> into place.
On mine if you put in extreme offsets it seems to lose sync. Not sure if this
To adjust the phase between the GPS 1 PPS and the 1 PPS derived from the
FE-5680A I put a switch in the divide by 1E7 logic used to get a 1 PPS from the
FE-5680A. Pushing the switch changes the divide so that the 1 PPS can be slewed
to a known phase WRT the GPS 1 PPS.
> Measurements of the delay between 1pps signals depend on the accuracy of
> the measuring
> device - e.g., the timebase in the counter of oscilloscope X axis.
Yes, but for a time interval of (for example) 100 usec even a very poor counter
timebase would be accurate to sub nsec. Of course, the FE-5680A could be used
as the counter timebase :-).
> On 12/28/2011 10:45 AM, Bob Smither wrote:
>> Chris Albertson wrote:
>>> Just got my fe5680 yesterday. Seems to work but the fe5680 is the most
>>> accurate reference I have. So how to test it? I plan to buy a
>>> Thunderbolt but until then, anyone have any creative ideas?
>>> Going to have to get a Thunderbolt. I have an Oncore UT+ the provides a
>>> good pulse per second but that will not help
>> You can take the FE-5680 10MHz and divide it down to a derived 1 PPS.
>> Use the time interval measurement on your HP5328A to measure the TI
>> between the Oncore 1 PPS (start) and the derived 1 PPS (stop).
>> You might want to set a finite TI (for example, 100 usec) by adjusting
>> the phase of the derived 1 PPS so the measurement doesn't get confused.
>> I have done this using an HP5316B with good results.
>> The jitter on the GPS 1 PPS might limit your short term resolution,
>> but over a day or so you should be able to measure the drift of the
>> I have used a Ref Tek 111A GPS clock for the 1 PPS. That unit has a
>> lot (several usec) of jitter. I recently started using a 111C that
>> has much lower jitter (a few 10's of nsec). I believe your OnCore
>> unit will be similar.
>> Here are some results from my tracking my FE-5680A:
>> Most recent:
>> Hope this helps.
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> and follow the instructions there.
Bob Smither, PhD Circuit Concepts, Inc.
Those who would give up essential Liberty, to purchase a little temporary
safety, deserve neither Liberty nor safety.
-- Benjamin Franklin: November 11, 1755
Smither at C-C-I.Com http://www.C-C-I.Com 281-331-2744(office) -4616(fax)
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 140 bytes
Desc: not available
More information about the time-nuts