[time-nuts] More 60 Hz graphs

[Tom Van Baak]

Hal,

Now that you're mastered sampling every cycle, it's a good time
to check how much of the noise or instability you see is due to
the h/w and s/w you're using vs. how much is due to the power
line itself.

Do you have a hp 3325 or similar synthesizer handy? Instead
of using 60 Hz from the power line, feed in a known stable or
accurate 60 Hz pulse source into the DCD pin and then see
how your plots look in comparison. It's an easy experiment to
do. The results will tell you how good/bad your PC-based time
interval counter really is.

Note it doesn't have to be 60 Hz; anything between say 10 and
100 Hz should work fine. By using a known stable and artificial
input signal all glitches and instability you see in the plots are
due to the sum total of h/w and s/w you're using. In effect the
PC is measuring its own noise without knowing it.

/tvb