[time-nuts] RCC 8000
GandalfG8 at aol.com
GandalfG8 at aol.com
Sun Dec 30 13:04:09 EST 2007
In a message dated 30/12/2007 17:45:51 GMT Standard Time, ernieperes at aol.com
writes:
Yes , I tried RadioClocks UK but no helping hand...they offered if I ship
the unit back to the factory,
??????? they give a price for the conversion...../ assume to expensive /...
??????? I am living about 25km from DCF77 in Germany, so believe the
receiver part is not a big deal,
??????? but the "code " is different then MSF60....
-----------------------------------------
Hi Ernie
I have some paperwork on the RCC8000, part, if not all, of some sort of
manual and perhaps some schematics too.
If that sounds vague it's because it was sent to me a few years ago and soon
ended up in storage.
I didn't reply earlier as I couldn't find it at home, which means it's
probably still buried in storage and I have no idea when I'm likely to find it.
If nobody else has a copy, and you don't mind waiting, I'm happy to share
what I've got.
It might be soon, but it could be quite a wait.
I have a couple of RCC8000s, also buried somewhere so it's a while since
I've seen them too, but I suspect any difference, aside from a fairly minor
retune of the receiver, is going to be in the firmware.
Both mine are for MSF and I have no idea whether or not there will be any
firmware information in the documentation I have.
I know it'll be a pain if you're so close to DCF77, but I don't think it
should be very difficult to knock up a reasonable antenna for MSF, which might
make life a lot easier.
regards
Nigel
GM8PZR
More information about the time-nuts
mailing list