[time-nuts] Lucent RFTG-m-XO

Robert E. Martinson REMartinson at rcn.com
Tue Feb 6 19:24:47 EST 2007

Thanks for the quick responses, Jim & Phil!

No, I was running the XO unit all by itself.  My guess is that the XO should
be able to run all by itself???   I have previously run with the XO & the RB
interconnected (J5 & 10 MHz Ref).  Not for 24 hours, but at least over
night, but No GPS stayed ON on both units, Fault was ON only on the XO.

Previously I have seen no activity on any pins of J6 on the XO, will check
again & also check J6 on the RB unit.  Maybe I really do have a serious

Am I correct in assuming that the data continuously streams out of each J6
connector without any interrogation being sent from a PC??

Bob Martinson, N1VQR

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Jim Miller
Sent: Tuesday, February 06, 2007 4:55 PM
To: Discussion of precise time and frequency measurement
Subject: Re: [time-nuts] Lucent RFTG-m-XO

On Feb 6, 2007, at 11:27 AM, Robert E. Martinson wrote:

> I'm about to conclude that I have a defective unit and will order
> another unless anyone has any further suggestions (PLEASE)?

Did you have the RB connected via the crossover cable and 10 MHz
cable as described in previous emails?


time-nuts mailing list
time-nuts at febo.com

More information about the time-nuts mailing list