[time-nuts] 75Z vs 50Z for GPS receivers (was Re: ACE-III GPS receivers (Dr Bruce Griffiths))

[Dr Bruce Griffiths]

Christopher Hoover wrote:
>> Most (except for Trimble,..) GPS receivers and antennas
>> are designed to use 50 ohm cable.
>> Trimble Bullet GPS antennas have a 50 ohm output impedance.
>> Trimble literature however is ambiguous in that in the
>> Resolution T receiver datasheets talk about using RG59
>> to connect to the antenna.
>>     
>
> FWIW, the Thunderbolt manual says this on page 3-5:
>
> --------
> Note - RG-59 is a 75 ohm coaxial cable. The ThunderBolt and
> the Bullet antenna are compatible with either 50-ohm or 
> 75-ohm cable. Compared to most 50 ohm cable, 75 ohm cable
> provides superior transmissibility for the 1.5 GHz GPS
> signal and a better quality cable for the price. Mismatched
> impedance is not a problem.
> --------
> --------
> Note - The input impedance of the ThunderBolt RF input &
> its antenna is 50 ohms.
> --------
>
>
> I would also add that BNC and N connectors come in both 50Z and 75Z flavors.
> In fact 75Z BNC connectors are pretty common, being used in professional
> video applications.  (Check surplus BNC patch cords carefully.)  On the
> other hand, 75Z N connectors are much less common, but were used in CATV
> plants, IIRC.
>
> -ch
>
>
>
> _______________________________________________
> time-nuts mailing list
> time-nuts at febo.com
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>
>   
Impedance mismatch can be more problematic when connecting the PPS 
output of a GPS receiver to a time interval counter.
RCA to BNC cables can catch one out if one doesn't notice that these use 
75 ohm coax.

93 ohm RG62 cables with BNC connectors are not unknown, they were used 
in some nuclear instrumentation.
I have a few of these lying around.

Bruce