[time-nuts] Troubleshooting SR DG435 Four Channel Digital Delay/Pulse Gen

[Brooke Clarke]

Hi Bruce:

The common pin has a 100 ns period wave at + and - 500 mv.
One of the center pins on the INT/EX switch had + and - 1 volt at 100 ns period.
Have Fun,

Brooke Clarke
http://www.PRC68.com
http://www.precisionclock.com



Dr Bruce Griffiths wrote:
> Brooke Clarke wrote:
> 
>>Hi:
>>
>>The DG535 Four Channel Digital Delay/Pulse Generator shows
>>Ext Clk Error on power up.
>>The obvious thing to do is turn the rear panel switch to INT, but after 
>>powering up with the switch in either position the same error message appears.
>>
>>Connecting an external 10 MHz to the clock input and with the INT/EX switch in 
>>either position the same error is there.
>>
>>The on line manual does not have schematics.  Any thoughts?
>>
>>  
> 
> Brooke
> 
> Is the longtailed pair Q502+ Q503 producing a 10MHz ECL level output signal?
> 
> Bruce
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>