[time-nuts] Pre-Release Docs and Schematics for the Fury Interface Board

Bruce Griffiths bruce.griffiths at xtra.co.nz
Tue Oct 30 00:58:21 EDT 2007


xaos at darksmile.net wrote:
> Hello everyone,
>
> The Fury Interface board is closer to reality!
>
> I think I have included everything in there. At least the things that  
> I would like to have. However, I am sure that the members of time-nuts  
> will add many suggestions.
>
> The pre-release documentation can be downloaded here at:
>
> http://www.gs3tech.com/
>
> Look for the documentation link, in the News Section, on the bottom of  
> the page.
>
> Please keep in mind that this is, very, preliminary information. There  
> will probably be errors and omissions.
>
> Once the schematic is done, then I'll finish the layout. Maybe I can  
> send the files to the board house by next Monday.
>
> At this point we are only planning to manufacture the board itself. We  
> do not foresee building a populated and assembled board. Perhaps a kit?
>
> However, this might change if the interest is there.
>
> This should also keep the costs down.
>
> Regards,
>
> George Hrysanthopoulos, N2FGX
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>   
If this board is intended to power an HP10544A some provision for the LC
power supply filter required by this oscillator should be made to avoid
adding large oven switching frequency related spurs to the oscillator
output.

Bruce



More information about the time-nuts mailing list