[time-nuts] using Fury GPSDO with Rb

Scott Mace smace at intt.net
Fri Apr 11 15:45:56 EDT 2008


I think the max for the FRS is 5.5v into 50ohms.

	Scott

SAIDJACK at aol.com wrote:
> Hi Scott,
>  
> I don't have access to the Fury schematics right now, but I believe the  Fury 
> 10MHz input is 50 Ohms terminated, so the TTL output would have to be able  
> to supply that load.
>  
> No other side effect, just make sure to adhere to the maximum input power  
> level (+13dBm I believe), even for TTL.
>  
> Hope that helps,
> bye,
> Said
>  
>  
> In a message dated 4/11/2008 11:20:25 Pacific Daylight Time, smace at intt.net  
> writes:
> 
> The  output of the Rb was TTL also.  What are the side effects
> of using  that with the Fury (other than not getting a sine  output)?
> 
> 
> 
> 
> **************Planning your summer road trip? Check out AOL Travel Guides.    
>   (http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016)
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> 
> 



More information about the time-nuts mailing list