[time-nuts] phase noise/jitter

Bruce Griffiths bruce.griffiths at xtra.co.nz
Mon Apr 28 17:49:20 EDT 2008

Don Collie jnr wrote:
> Hello Bruce and all,
>     OK, now I think I understand : the more phase noise on the VCO, the more jitter on the output of the divide by "N".
>     This output spectrum comprises *only* the PRF+ close-in noise sidebands [plus harmonics, and their noise sidebands]. Since the lowest frequency [ignoring close-in noise sidebands for a moment] present in the divide by "N"
> logic is equal to its output frequency anyway, there are no frequencies present in the output that are below this,
May not true when there are spurs on the VCO output.

 and because the loop rolls off at a frequency that is much less than 
this, the VCO is not modulated by any signal comming from the reference, 
or the divide by "N" logic ..The loop filter filters these signals 
out.This is how a PLL can "clean up" jittery signals. So I guess one way 
to improve PLL phase noise is to have as high a frequency going to the 
phase detector as possible, and to have as low a loop bandwidth as 
possible, [and put up with a long lock - in time].Having now filtered 
out most of the jitter, the problem becomes one of designing a VCO [or 
variable reluctance oscillator, as in a YIG], that produces little phase 
noise of itself. This must be where the designers get crafty!
> Facinating stuff !,....................................................Don C.

More information about the time-nuts mailing list