[time-nuts] New 10mhz Distribution Amplifier

[Ulrich Bangert]

Rick,

> Compare, for example, the HP5087, a so-so design, to the
> output amplifier design in the 5071A cesium, as documented
> in my FCS paper in 1992.  Huge difference in specs.  The
> 5071A has 120 dB isolation between outputs.

If I look at your FCS92 paper and specially to figures 5 and 6: Do I
understand you correct in the sense that you are proposing a less
analogue and more digital styled distribution amplifier with a near-sine
construction from an digital clock and analogue output filtering for
every output or are you just refering alone to the triangle amplifier
building blocks to be seen in figure 5?

73s Ulrich, DF6JB

> -----Ursprungliche Nachricht-----
> Von: time-nuts-bounces at febo.com 
> [mailto:time-nuts-bounces at febo.com] Im Auftrag von Rick Karlquist
> Gesendet: Freitag, 15. August 2008 00:37
> An: Discussion of precise time and frequency measurement
> Betreff: Re: [time-nuts] New 10mhz Distribution Amplifier
> 
> 
> Additional specs to consider:
> 
> The return loss should be low for 10 MHz and the first 8 
> harmonics. The harmonic distortion should be low. The 
> isolation between outputs should be high. The phase drift vs 
> temperature should be low. The short term stability at 1 
> second should be good. The magnetic field susceptibility 
> should be low. Line sidebands should be low.
> 
> Compare, for example, the HP5087, a so-so design, to the
> output amplifier design in the 5071A cesium, as documented
> in my FCS paper in 1992.  Huge difference in specs.  The
> 5071A has 120 dB isolation between outputs.
> 
> Rick Karlquist N6RK
> 
> 
> Bruce Griffiths wrote:
> > Doug Millar wrote:
> >> Hi,
> >> 	A new 10mhz distribution amplifier is available at 
> amateur prices. 
> >> Jerry N7EME is producing them. His website is at 
> >> http://jwmeng.com/model_RDA-6.html
> >> 	Doug K6JEY
> >>
> >>
> >>
> > There's  a few specifications missing:
> >
> > 1) input impedance and return loss.
> >
> > 2) output impedance and return loss
> >
> > 3) phase noise
> >
> > These are essential if one is to make a rational decision on the 
> > suitability of the distribution amplifier.
> >
> > The outputs and inputs appear to share a common ground.
> > This would preclude its use in some setups without external 
> means of 
> > providing the required isolation.
> >
> > The other question is does the device use AGC to set the 
> output level? 
> > If it does the phase noise floor will almost inevitably be 
> relatively 
> > high compared to the state of the art.
> >
> > Bruce
> >
> > _______________________________________________
> > time-nuts mailing list -- time-nuts at febo.com
> > To unsubscribe, go to 
> > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> > and follow the instructions there.
> >
> >
> 
> 
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-> bin/mailman/listinfo/time-nuts
> and 
> follow the instructions there.
>