[time-nuts] NTPns Configuration Settings?

Jason Rabel jason at extremeoverclocking.com
Sun Feb 3 12:48:02 EST 2008

>>So far my conf file looks like:
>>oncore 0 serial /dev/cuad1
>>oncore 0 pps device /dev/elan-mmcr
>>oncore 0 pps flank assert
>>ntpv4 0 listen *
>>telnet port 123
>>telnet enable
>This looks good.
>Useful commands from the telnet prompt:
>    "show oncore 0"
>    "show source"
>    "show source oncore_0"
>    "show source oncore_0 allan"
>    "show ntpv4 0 partner"
>    "show ntpv4 0 partner all"

Thanks for the tips PHK! Right now the GPS is getting its almanac, it has
been sitting unused for several months. I don't know if I will be able to
get any useful information from it before I have to leave in 20min, but
tomorrow should have plenty of time to tinker with it.

One question, in the documentation I noticed there was a source that was an
IP address (in a sample "show source" output). Can you list other NTP
servers as sources? If so, what is the config line?

More information about the time-nuts mailing list