[time-nuts] Datum/Symmetricom BC637PCI Time and Frequency Processor

Rob Kimberley rk at timing-consultants.com
Tue May 6 03:15:21 EDT 2008


I have some CDs in the store room, which Datum produced which have all their
driver software on. I know they are in there somewhere, but since moving the
last time (domestic split!), I haven't had a chance to sort through a lot of
this stuff.

Will try to take a look over the next couple of days, and if they are still
there, then I'll send it over.


-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of GandalfG8 at aol.com
Sent: 06 May 2008 00:35
To: time-nuts at febo.com
Subject: [time-nuts] Datum/Symmetricom BC637PCI Time and Frequency Processor

Hi All
I've just bought a Datum BC637PCI Time and Frequency Processor on a PCI
card from the usual place, model BC635PCI is identical but without  the
onboard GPS receiver, and am looking for any Windows drivers  and/or the
basic control software.
I've found the manual and other documentation online, also documentation
for the very similar Symmetricom BC637PCI_U that replaced it, but cannot
find the drivers or software for either.
The original Datum config and demo program was BC635CPP.exe, and
TRAYTIMECPP.exe was a system clock utility.
Symmetricom continued to supply Bc635cpp.exe with the BC637PCI_U but the
clock utility was now named TrayTime.exe and there was also some GPS demo
software called bc637PCI GPS Demo.
I have 7 days after receipt to determine if all is working ok so if anyone
can help, particularly with a copy of BC635CPP.exe, I'd be very  grateful.

time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
and follow the instructions there.

More information about the time-nuts mailing list