[time-nuts] Tbolt monitor software

[Didier Juges]

I had the same problem here, and as it has been indicated, in my case it was
also the unidirectional connection (commands from the PC never made it to
the TB, so some data that is not automatically put out never got to the PC).
I had a bad pin on the serial port connector.

Check your wiring and signal levels, from the PC to the TB.

Didier KO4BB 

-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of VK3FGJM
Sent: Wednesday, January 21, 2009 2:32 PM
To: time-nuts at febo.com
Subject: Re: [time-nuts] Tbolt monitor software

Hi,

Yes, I can see alarm status and changes when unplugging antenna etc.

As mentioned the unit actually works, just no data certain displayed.

Regards,

Gerald
VK3FGJM



-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of n3izn at aol.com
Sent: Thursday, 22 January 2009 3:55 AM
To: time-nuts at febo.com
Subject: Re: [time-nuts] Tbolt monitor software

Did you select the right comm port? I power mine off a lot and it has always
come back.


-----Original Message-----
From: VK3FGJM <VK3FGJM at commtelns.com>
To: time-nuts at febo.com
Sent: Wed, 21 Jan 2009 5:29 am
Subject: [time-nuts] Tbolt monitor software



Hi group,
 
A strange situation has led me to ask a question about the Tbolt GPSDO and
the Trimble Thunderbolt monitor s/w version 2.6.
 
While re-arrangement of the shack, it's been idle for 3 weeks, Tbolt turned
off. After turning the unit on and letting it settle some 2 hour, I
connected the monitor program and found the following that I can not explain
and correct:-

*   All SV and AMU have question marks
*   Product info has questions marks
*   the ability to see tracking status is blank.

When last used, some 2 months ago to show a friend, the relevant display
data came up, no issues. Further more, position, critical and minor alarms
are green, disciplining status section such as DAC voltage DAC value mode
and even it's 10MHz out etc etc is fine compared to my trusty Rubidium
standard.
 
Has any one seen this before and is there a setting that may have inhibited
this feature?
 
I have a screen shot, however it may be to large to attach, so let me know
if this will help, I will be glad to forward it to some one with much more
knowledge.
 
Thank you in advance.
 
Regards,
 
 
Gerald
 
VK3FGJM
 
 
 
 
 
 
 

 

_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
--
Message  protected by MailGuard: e-mail anti-virus, anti-spam and content
filtering.
http://www.mailguard.com.au/mg



_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.