[time-nuts] AMU vs dBc
Mark Sims
holrum at hotmail.com
Tue Nov 24 02:16:47 UTC 2009
Alas, there is no way to get a direct conversion between AMU and dBc. What you have to do is display the signal levels in dBc and then switch the unit to AMU. It takes it a couple of seconds before it switches. By then the signal levels have changed, so that the data is only approximate. The lower signal levels seem to change the most so I have been unable to get any reliable/repeatable readings.
Even setting the AMU mask level and watching where sats turn yellow/green does not work well. There appears to be some hysterisis/filtering/delay in the selection/deselection process.
----------------
Can you also see what 0.0, 0.5, 1.0, 1.5, 2.5, 3.0 are equal to.
Those are the important ones when setting the AMU lower.
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141665/direct/01/
More information about the time-nuts
mailing list