[time-nuts] 5370A

Joseph Gray jgray at zianet.com
Sat Oct 10 19:55:33 UTC 2009


The heatsink on my unit is quite hot, also. I'm thinking about putting
a fan on it after I get everything working.


On Sat, Oct 10, 2009 at 9:24 AM, Greg Burnett <gbusg at comcast.net> wrote:
> Roy,
>
> The HP 5370A rear mounted heat-sink typically heats up to around 61 degrees
> C. This is very hot to the touch, so I suspect your unit's temperature is
> normal (unless it's running way hotter than 61 degrees C).
>
> The buzzing transformer might just be due to loose, vibrating laminations.
> You might try tightening the transformer's bolts to see if that reduces the
> buzz?
>
> Best,
> Greg
>
> P.S. I agree that the rear mounted heat sinks of most other HP equipment run
> significantly cooler. The models that run so hot to the touch are the
> 5370A/B, 5359A, and many of the legacy HP pulse generators (from Boblingen
> Division).
>
>
> ----- Original Message -----
> From: "Roy Phillips" <phill.r1 at btinternet.com>
> To: "Discussion of precise time and frequency measurement"
> <time-nuts at febo.com>
> Sent: Saturday, October 10, 2009 4:08 AM
> Subject: Re: [time-nuts] 5370A
>
>
> Hi Joe
> I have a similar problem so I would be pleased to hear from you with any
> useful information. The basic problem with mine is that the power supply is
> suspect - it works, but there is excessive heat, much greater than any other
> HP instrument that I have, from the rear mounted heat-sink, this is too hot
> to hold your hand on ! There is also a very obvious buzz from the power
> transformer, even when it is on "stand-by" - so I guess at worst it could be
> shorted turns in the power transformer, or probably better, a faulty bridge
> rectifier,or one or more of the large reservoir caps -  this an early model
> (1984), so perhaps it is to be suspected. I also think the performance is
> not to specification, but I will check-out the perceived problem with PSU
> before I investigate this matter.  I am just about to start the
> investigation of the prime problem.
> Roy
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>



More information about the time-nuts mailing list