[time-nuts] TADD-1 Documentation Error

[Don @ True-Cal]

John,

Thought I would ride alond on this email thread and ask about my TAPR TADD-1, Enclosure and TB order from back in June. At that time, shipping was targeted for Sept.

Order under Don Johnson, True-Cal
 Regards...
Don 




________________________________
From: John Ackermann <jra at febo.com>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Sent: Thursday, September 17, 2009 6:34:16 PM
Subject: Re: [time-nuts] TADD-1 Documentation Error

Thanks!  That's the first time that's been noted in the years since the docs were written. :-)

John
----

Brian Kirby said the following on 09/17/2009 05:31 PM:
> John - N8UR
> 
> On page 13; titled Initial Test -- 2; there is a documentation error in the middle section; Integrated Circuit Installation -- 2.
> 
> "Install a MAX477 IC at IC2, IC2, IC3, IC4, IC5, IC6, IC7"
> 
> Should start with IC1.....
> 
> Brian - KD4FM
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.