[time-nuts] Fw: NE602AD as frequency doubler

Bob Camp lists at rtty.us
Tue Aug 24 20:30:00 UTC 2010


If you want a fairly clean 80 MHz, you will need a bit more bandpass filtering. Doing the filtering and the phase shift at the same time probably makes sense. Dif amp doublers may be simpler overall. Normally a doubler is implemented as a single transistor stage driven to clipping with a tuned collector - even fewer components.


On Aug 24, 2010, at 4:16 PM, Stanley Reynolds <stanley_reynolds at yahoo.com> wrote:

> ----- Forwarded Message ----
> From: Stanley Reynolds <stanley_reynolds at yahoo.com>
> To: time-nuts at febo.com
> Sent: Tue, August 24, 2010 2:58:04 PM
> Subject: NE602AD as frequency doubler
> Attached is a cut and paste from several sources with most of the circuit from 
> the Phillips' application note 1983 Figure 15.
> The application note does not specify component values but I found a calculator 
> online just not sure it applies.
> Any help would be appreciated.
> Stanley
> <8x.JPG>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list