[time-nuts] PICTIC II PCB order placed
Stanley Reynolds
stanley_reynolds at yahoo.com
Fri Jul 2 16:46:57 UTC 2010
Oops, I didn't know this was on the list been getting a lot of off list stuff.
Some of my own emails to the list get lost before they get to me, others are
delayed this is a on going problem probably a yahoo spam filter overload.
UPDATE on order:
I have placed the order for more boards than needed and hope to receive them in
less than 2 weeks.
As far as shipping think it will be easy for me if we call it 1 USD per board. I
will let everyone gage when they need to mail their US funds check/money order.
If you are paying by paypal add 50 cents per board for a total of 9.50. No need
for payment till I receive the boards unless you are unsure how long it will
take for me to receive it.
Stanley Reynolds
225 Alpine Street
Birmingham, AL 35210
USA
If your software will only work with Irondale and not Birmingham this is OK
Stanley Reynolds
225 Alpine Street
Irondale, AL 35210
USA
paypal stanley_reynolds at yahoo.com
----- Original Message ----
From: Bob Bownes <bownes at gmail.com>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
Sent: Fri, July 2, 2010 10:45:36 AM
Subject: Re: [time-nuts] Pic programing for the PICTIC II
Ok. I think there are a few of us who can/would program these up for
folks who need one.
On Fri, Jul 2, 2010 at 11:43 AM, Stanley Reynolds
<stanley_reynolds at yahoo.com> wrote:
> Thank you but I have all I want to do with the boards later I may change my
> mind.
>
> Stanley
>
<snip>
More information about the time-nuts
mailing list