[time-nuts] Austron 2100F

[Stan, W1LE]

Hello Tony,


Do you have the manual ?
My june, 1983  2100F op and maintenance manual, page 3-13 indicates:

E #1 is a - or acquisition not in progress,  cleared by software

E#2 is a E,   normal tracking has been halted due to a loss of external 
reference
   The operator clears this bit manually by restoring the external 
reference.

E#3 is a - ,    noise number is less than 4000

E#4 is a - ,    no blinking

E#5 is a -  ,   servos active

E#6 is a E    not yet in tracking mode . this bit is cleared by software.



On page 3-14: The STATUS indicators are displayed by (keystrokes)  STATUS  6

To clear the indicators, enter 0   STATUS   6

I found no other method of a deep reset.

Take a look at the external reference connection to be sure it is 
recognized..

Any questions, send them along.

Stan, W1LE      Cape Cod




On 10/21/2010 6:55 PM, Chuck Harris wrote:
> Are you sure that your Loran chain is still up?  In the US and
> Canada, Loran has been decommissioned.
>
> -Chuck Harris
>
> asmagal at fc.up.pt wrote:
>> Hello!
>>
>> After power up, my 2100F Loran-C receiver displays
>> (E 1002048) followed by (E-20), as usually, but recently
>> I have a trouble: after that the TRACKING led goes RED
>> still and the display shows (- E - - - E).
>> Running the test subroutines 1 to 4 everything seems
>> to be OK but the fault persists.
>> Entering the sequence (0, STATUS, 6) doesn't clear the
>> error.
>> Does someone knows how to make a deep reset for
>> clearing all the errors?
>>
>> Thanks in advance.
>> Antonio
>> CT1TE
>>
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>