[time-nuts] Austron 2100F

paul swed paulswedb at gmail.com
Fri Oct 22 13:14:47 UTC 2010

Thats what I was thinking also on the reference and emailed back to the
I believe over time that internal switch to select 1,5,10 mc can get a bit
If a operating reference is connected and checked to be correct toggle the
switch a few times to clean its contacts. It gets lonely sitting in there by
itself for years. ;-)

On Fri, Oct 22, 2010 at 8:12 AM, Chuck Harris <cfharris at erols.com> wrote:

> Hi Antonio,
> Ok.  I just wanted to be sure that it was still up in Europe.  Canada
> dropped their chains 3 months earlier than they said they would.  And
> since Loran-C is no longer usable world wide, I figure Europe will be
> dropping their chain soon.
> The error indication you have described tells me that you have no
> reference oscillator.  This could be for a couple of reasons:
> 1) you have no frequency standard connected to your 2100F
> 2) the switch, labeled 1-5-10, on the board stack visible when you hinge
>   open the front panel is set incorrectly for your external frequency
>   standard.
> 3) Your 2100F is broken.
> -Chuck Harris
> asmagal at fc.up.pt wrote:
>> Chuck,
>> I am in Portugal, currently receiving the European
>> 6731 LESSAY Chain.
>> Best regards,
>> Antonio
>> CT1TE
>> Quoting Chuck Harris <cfharris at erols.com>:
>>  Are you sure that your Loran chain is still up? In the US and
>>> Canada, Loran has been decommissioned.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list