[time-nuts] T.I. experimenting - newbie question
David C. Partridge
david.partridge at perdrix.co.uk
Sun Apr 3 19:33:26 UTC 2011
With any decent TDR you can SEE all the connections so you can measure the cable length (+/- a few mm) directly.
Regards,
David Partridge
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On Behalf Of Magnus Danielson
Sent: 03 April 2011 12:46
To: time-nuts at febo.com
Subject: Re: [time-nuts] T.I. experimenting - newbie question
On 04/03/2011 12:40 PM, Hal Murray wrote:
>
>> If I understand you correctly, then I did not have things setup
>> symetrically. Now I have a tee on each of the A and B inputs. The
>> unused port on the B tee has a 50 Ohm terminator. Is this what you mean?
>
> Symmetry makes it easier to see what is going on. If you use a Tee on
> the B input, then the timing from the center of the Tee on the A input
> to the internal logic should match the same setup on the B port. That
> lets you focus on what is between the two Tees.
Trouble is that you have added the electrical length of a tee inbetween the center-to-center distance. You still need to calibrate that out of the equation. Still not much, but it's a bias.
Consider that you have three cables (tc1, tc2, tc3), a barrel (tb) and input offset (toff).
You measure them
t1 = toff + tc1
t2 = toff + tc2
t3 = toff + tc3
t4 = toff + tc1 + tb + tc2
t5 = toff + tc1 + tb + tc3
t6 = toff + tc2 + tb + tc3
6 measurements for 5 unknowns should work out well. Remove one cable and you only make 3 measurements for 4 unknowns.
>> With the above setup, using the shortest cable I have gives me 1.5 ns.
>> Adding the longer cable to the shorter, using a F-F BNC coupler gives
>> me 21 ns, for a difference of 19.5 ns.
>
> Adding the barrel complicates things. What is the delay through the barrel?
> (My guess would be about an inch at 50% of c, so that's ballpark of
> 0.2 ns.)
>
> If you swap the short cable for a longer one, then the only difference
> is the change in length.
Only helps for diffrence in delay, not actual delay.
Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list