[time-nuts] DG535 triggering problem
Brooke Clarke
brooke at pacific.net
Fri Dec 16 18:25:45 UTC 2011
Hi Kevin:
Just a guess. If line triggering does that there may be a problem with the power transformer.
Use an Ohm meter to locate the transformer terminals for the AC line and then check from one of those to all the other
terminals.
I suspect there's a short in the transformer.
Look at U502 to see of it's burned up.
Have Fun,
Brooke Clarke
http://www.PRC68.com
http://www.end2partygovernment.com/Brooke4Congress.html
Kevin Rosenberg wrote:
> Hello,
>
> Thanks to Brooke's excellent web page [1] on getting the DG535
> 80 MHz clock working, I was able to fix the "Ext Clk Err" on
> a DG535. Everything on the front panel seems to work.
>
> However, triggering does not work. I can't get a trigger to
> occur in any triggering mode. Setting the triggering mode to
> 'Line' causes a loud 120 Hz vibration from the rear of the device.
>
> I've checked voltages from all of regulators mentioned in
> the manual, and they seem fine.
>
> I wonder if someone has an idea about helping the DG535
> trigger.
>
> Thanks,
>
> Kevin
>
> [1] http://www.prc68.com/I/TandFTE.shtml#DG535
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
More information about the time-nuts
mailing list