[time-nuts] Austron 1150
EWKehren at aol.com
EWKehren at aol.com
Tue Feb 1 14:44:04 UTC 2011
Arthur
I have the both, the screwdriver adjust only will probably make a good
offset for the Dual Mixer. I just checked one, it tunes 3 Hz down and 1.5 Hz up
In a message dated 2/1/2011 9:39:08 A.M. Eastern Standard Time,
golgarfrincham at yahoo.com writes:
"Does any one have information on the Austron 1150 oscillator?"
I have seen 2 different variations of this oscillator.
There is one that was used in the 1210D standard
that has a BNC connector besides the 9-pin connector
and this unit has EFC input on the 9-pin connector.
The second does not have the BNC connector and
also does not have any EFC capability, just a screw
adjustment. The specs may differ as well but both
are pretty good oscillators.
-Arthur
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list