[time-nuts] Achievable temperature stability for Thunderboltenvironment
warrensjmail-one at yahoo.com
Sun Jan 16 19:29:12 EST 2011
Lady Heather has a built in software PID Temperature controller.
The setpoint to the PID is done using the "TT" command,
the feedback is from the Tbolt's temperature sensor and
the output is a 1 sec PWM signal that comes out on pin 4 (and others?)
The real problem is to try and find the doc on how to use it all.
I'll leave that answer to others.
[time-nuts] Achievable temperature stability for Thunderboltenvironment?
Kevin Rosenberg kevin at rosenberg.net
Mon Jan 17 00:12:40 UTC 2011
On Jan 16, 2011, at 4:46 PM, WarrenS wrote:
> I don't know if this low resolution picture will post correctly.
> If anyone wants a high resolution view of the H/W,
> or an expanded plot showing the results over a 2 week period,
> I can provide them, if someone will send me the name of a site to post them at.
The photo and schematic were clear, thanks for posting! I see that you have
the fan controlled by pin 4 of the RS-232. Is there a mechanism in Lady Heather
to control pin 4 (DTR) based on temperature readings? Or, maybe you monitor the
temperature and control pin 4 with some other monitor/control program using an
output different that the RS-232 port controlled by Lady Heather?
Anyway, that's a great looking temperature plot, and the implementation is nicely
simple. Lots of bang for that buck!
More information about the time-nuts