[time-nuts] Completely OT: Removing electrolytics of leaking capacitors from a pcb

Werner Zychlinski Silverhead at gmx.net
Wed Jan 19 09:56:34 EST 2011


Ulrich,

In a lost cause I will use the "Nitro-Universalverdünnung" (it's aggressive to some plastics, take care) and after them "Tuner 600"


Werner Z.
Bremen,Germany

-------- Original-Nachricht --------
> Datum: Wed, 19 Jan 2011 15:02:34 +0100
> Von: "Ulrich Bangert" <df6jb at ulrich-bangert.de>
> An: "Time nuts" <time-nuts at febo.com>
> Betreff: [time-nuts] Completely OT: Removing electrolytics of leaking	capacitors from a pcb

> Gentlemen,
> 
> I know this is completely out of topic but I know there are some dedicated
> material experts among you. So please allow me to put the following
> question
> forward: 
> 
> Is there any good suggestion available on how to remove electrolytic
> coating
> resulting from leaking electrolytic capacitors from a pcb? It is not a
> question of good looking, the coating seems to have a real "electrical
> conducting" property which is absolutely bad on higher-impedance circuitry
> as to be found on a Tektronix TDS45A scope mainboard, where the problem is
> encountered. The findings so far are that the classical method with
> isopropanol and a brush won't work. And the internet won't give precise
> answers for that problem.
> 
> Any suggestion is highly appreciated!
> 
> Best regards
> 
> Ulrich Bangert
> www.ulrich-bangert.de
> Ortholzer Weg 1
> 27243 Gross Ippener 
> 
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

-- 
NEU: FreePhone - kostenlos mobil telefonieren und surfen!			
Jetzt informieren: http://www.gmx.net/de/go/freephone




More information about the time-nuts mailing list