[time-nuts] Results parts selection + commercial assembly poll?

[Bob Bownes]

I'll add that for some reason the discussion never morphed over to an
alternate list created just to discuss a counter project without
taking up bandwidth here. Not sure that there was enough interest.

Other Bob


On Mon, May 16, 2011 at 11:53 AM, Bob Camp <lists at rtty.us> wrote:
> Hi
>
> The polls ran for less than a day before they drew considerable fire for
> using too much bandwidth. Since we still had several steps to go (what to
> design, what to design it with, and who to design what), it was dropped.
> Doing a group general purpose FPGA based timing board isn't going to happen
> within the perceived bandwidth limits here.
>
> Bob
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Tijd Dingen
> Sent: Saturday, May 14, 2011 5:04 PM
> To: time-nuts at febo.com
> Subject: [time-nuts] Results parts selection + commercial assembly poll?
>
> Incidentally, did something ever come of these two polls? I was trying find
> the conclusion / results, but could not find it on the list. Entirely
> possible that I am blind for which I apologize in advance. Anyone know what
> came of it?
>
> regards,
> Fred
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>