[time-nuts] GPSDO - internal connections question
Bob Camp
lists at rtty.us
Wed Sep 21 21:08:59 UTC 2011
Hi
Twisted pair is fine for the EFC. Shielded twisted pair (one end grounded on
the shield) might be slightly better). A lot depends on how many yards long
the EFC wire is :)....
Bob
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Chris Howard
Sent: Wednesday, September 21, 2011 4:46 PM
To: Discussion of precise time and frequency measurement
Subject: [time-nuts] GPSDO - internal connections question
I'm building a GPSDO using the VE2ZAZ board, an HP 10811 oscillator and
a Trimble Resolution T GPS.
My goal is a simple and cheap 10 Mhz standard for my little home
electronics bench and ham shack.
I have my power supply parts finally gathered up, now I have these
boards that need interconnecting.
I'm thinking I need to use coax cable for anything that has 10 Mhz on
it. Do I need to shield
the control voltage going to the oscillator
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list