[time-nuts] Temperature and signal amp for 'Bay FE-5680A?
Hal Murray
hmurray at megapathdsl.net
Sat Jan 7 22:53:56 UTC 2012
> So, here's a question. One app is a rack of gear which all needs to get
> the 10 MHz. I could just go find some distribution amp, but I would prefer
> to build something. Has anyone done this?
Sine or square wave?
I was thinking
perhaps a good
> solid reasonably high power op amp buffer feeding resistors to each output
> to each piece of gear? Anyone done this and found any "gotchas" or success
> stories?
The advantage of that scheme is simplicity. The disadvantage is reduced
isolation in case you have crap coming back from one of the devices you are
feeding.
I second the suggestion to scan the documentation for the TAPR distribution
amplifier.
There are actually two of them, one for RF and another for PPS/digital.
http://www.tapr.org/kits_tadd-1.html
http://www.tapr.org/~n8ur/TADD-1_Manual.pdf
http://www.tapr.org/kits_tadd-3.html
http://www.tapr.org/~n8ur/TADD-3_Manual.pdf
Thanks John.
--
These are my opinions, not necessarily my employer's. I hate spam.
More information about the time-nuts
mailing list