[time-nuts] FE-5680A adjustment screw?

Chuck Forsberg WA7KGX N2469R caf at omen.com
Wed Jan 18 14:12:36 UTC 2012


The circuit board near the 9 pin connector has a number of pads
which appear to be option jumper sites.   If so it would be nice to
know what they do.... just think of the possibilities..

On 01/18/2012 04:44 AM, Bill Riches wrote:
> it does nothing - not connected - you might look at the 5680 archives - this
> and a bunch of other info is listed ad nauseum about the 5680.
>
> 73,
>
> Bill, WA2DVU
> Cape May, NJ
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Robert Benward
> Sent: Tuesday, January 17, 2012 10:01 PM
> To: Discussion of precise time and frequency measurement
> Subject: [time-nuts] FE-5680A adjustment screw?
>
> Hi all,
> Anyone know what the little adjustment hole is on the side of the FE-5680A?
> Is this a frequency adjustment?  I tried adjusting it but nothing happened.
> Was the adjustment range too small to see a change on a counter?
>
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>

-- 
Chuck Forsberg WA7KGX N2469R     caf at omen.com   www.omen.com
Developer of Industrial ZMODEM(Tm) for Embedded Applications
   Omen Technology Inc      "The High Reliability Software"
10255 NW Old Cornelius Pass Portland OR 97231   503-614-0430




More information about the time-nuts mailing list