[time-nuts] Rapco 1804m
Chris Albertson
albertson.chris at gmail.com
Sat Jun 9 17:42:47 UTC 2012
On Sat, Jun 9, 2012 at 10:34 AM, Paul Flinders <paul at flinders.org> wrote:
>
> Went off to do some other stuff then came back to find it just in a loop
> resetting itself, running for a few seconds, then resetting itself again.
>
> It had also clearly forgotten it's idea of the current time as it now
> reports a UTC time of just a few minutes past midnight 1/1/99.
>
> Does anyone know if there is there any common fault or operating problem
> that would make it do this
>
Could be any kind of internal failure. But I'd check out the antenna and
the antenna feed line. I've seen broken ground shields and water wicked
inside the coax, is there DC in the center conductor (as measured at the
antenna end of the cable) so the amp inside the antenna can be powered. Is
the DC voltage correct? Does the antenna work with some other GPS
receiver?
>
>
> ______________________________**_________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/**
> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts>
> and follow the instructions there.
>
--
Chris Albertson
Redondo Beach, California
More information about the time-nuts
mailing list