[time-nuts] Trimble T'Bolt

George Dubovsky n4ua.va at gmail.com
Fri Mar 23 13:52:26 UTC 2012


Yes, you can, but you need to transplant the in-line power header in the
"old" board to the "new" board and mount it on the "back" side of the pwb.

73,

geo - n4ua

On Fri, Mar 23, 2012 at 9:46 AM, J. L. Trantham <jltran at att.net> wrote:

> Probably older.  Date Code is 9932.
>
> However, I wonder if you could 'transplant' a newer TBolt into the case and
> use the built in 24 VDC power supply?
>
> Joe
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Stan, W1LE
> Sent: Friday, March 23, 2012 8:34 AM
> To: 'Discussion of precise time and frequency measurement'
> Subject: [time-nuts] Trimble T'Bolt
>
>
> Hello The Net,
>
> On Ebay: 120880795618
>
>
> Is this a very old T'Bolt or the newer e T'Bolt  ?
>
> I like the single power supply even though it is 24VDC
>
> Stan, W1LE    Cape Cod
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>


More information about the time-nuts mailing list