[time-nuts] Trimble recommends RG-59 Antenna Cable.
Eric Lemmon
wb6fly at verizon.net
Tue May 1 00:39:05 UTC 2012
Ken,
I believe that the manual also states that RG-59 has lower loss than RG-58,
but I would use RG-6 for even lower loss. Neither the antenna nor the
Thunderbolt cares much about the cable impedance.
73, Eric Lemmon WB6FLY
-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
Behalf Of Ken Kubick
Sent: Sunday, April 29, 2012 10:58 PM
To: Time Nuts
Subject: [time-nuts] Trimble recommends RG-59 Antenna Cable.
Hi Time-Nuts guys, I was reading the Trimble Thunderbolt manual section
2.1.3 (Antenna Cable). Trimble recommends using RG-59 cable which is 75 ohm
coax. Is this a typo or is this correct? I thought that the Trimble
Thunderbolt would use a 50 ohm cable and antenna.
Thankyou
Ken Kubick
kenkubick at hotmail.com
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts
mailing list