[time-nuts] OT : different Rx and Tx baud rate on same port

[Tom Van Baak]

Björn,

If you can't find a black box that does this, just use two serial ports: Rx from one and the Tx from the other. On the software side it means opening two devices, but that shouldn't be hard to handle.

Note bb-elec.com used to make a cute 4-port serial concentrator that would allow you to configure different baud rates in/out, but I see that's no longer a current product.

Of course you could do all this with a micro or SBC, but I assume you're looking for a turn-key device rather than a homebrew project.

/tvb

----- Original Message ----- 
From: ""Björn"" <bg at lysator.liu.se>
To: <time-nuts at febo.com>
Sent: Friday, December 06, 2013 4:14 PM
Subject: [time-nuts] OT : different Rx and Tx baud rate on same port


Hi,

I am looking for current serial adapters that support split baud rates.
That is different input and output baud rate.

Grateful for suggestions!

kind regards,

     Björn