[time-nuts] SSR-6t Connector
Dale J. Robertson
dale at nap-us.com
Sat Jan 5 17:38:03 UTC 2013
That header is used for programming the on board PIC. I've rung it out as follows:
Header pin 1 -> PIC pin 18 MCLR (active low)
Header pin 2 -> PIC pins 28 & 40 VDD
Header pin 3 -> PIC pins 29 & 39 VSS
Header pin 4 -> PIC pin 21 PGD1
Header pin 5 -> PIC pin 22 PGC1
73
Dale NV8U
Sent from my iPhone
On Jan 5, 2013, at 6:46 AM, "David J Taylor" <david-taylor at blueyonder.co.uk> wrote:
> Does anyone have the pin-out for the 5-pin connector on this board? The 10-pin connector is documented, but not the single-in-line 5-pin connector near the label HGR200 (?). I didn't see it documented in this thread either.
>
> Thanks,
> David
> --
> SatSignal Software - Quality software written to your requirements
> Web: http://www.satsignal.eu
> Email: david-taylor at blueyonder.co.uk
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list