[time-nuts] What cut do I have?
Magnus Danielson
magnus at rubidium.dyndns.org
Sun Jan 27 19:40:21 EST 2013
On 01/28/2013 01:01 AM, Ed Breya wrote:
> If you meant to say the frequency starts out too high when the oven is
> cold, then I think it's AT cut.
OK. I looked at the previous posts and it was not very clear from them,
and I was too lazy/busy to heat up an idel AT OCXO. I just felt the
+41.4 ppm deviation was a little low for an AT cut.
Meanwhile, out of 22 LPROs tested, only 3 has BITE error, so 19 locks
up. Out of 4 cesiums tested, 3 locks up and one fails. Trimming needed
on all.
Cheers,
Magnus
More information about the time-nuts
mailing list