[time-nuts] Lady Heather numbers

Garren Davis garren.davis at qlogic.com
Tue Mar 12 17:39:00 EDT 2013

I did see those photos. They gave me confidence to cut it open to see if there was
anything I could do to fix it.


-----Original Message-----
From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On Behalf Of Arthur Dent
Sent: Tuesday, March 12, 2013 2:16 PM
To: time-nuts at febo.com
Subject: [time-nuts] Lady Heather numbers

>Garren Davis garren.davis at qlogic.com Tue Mar 12 12:55:48 EDT 2013
>I found the 1 ohm resistor from the 12 volt pin to the heater circuit
>popped off its solder pads and was laying between the insulation and
>the metal enclosure.

You might want to check the 2 photos and the description of the OXCO I posted on Wed Feb 27 14:09:01 EST 2013 to give you a visual of the innards. Photo links are repeated below.


time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.


This message and any attached documents contain information from QLogic Corporation or its wholly-owned subsidiaries that may be confidential. If you are not the intended recipient, you may not read, copy, distribute, or use this information. If you have received this transmission in error, please notify the sender immediately by reply e-mail and then delete this message.

More information about the time-nuts mailing list