[time-nuts] Distribution amps for Thub=nderbolt and David partridges divider box?
Chris Wilson
chris at chriswilson.tv
Sat May 18 18:04:44 EDT 2013
>> Subject: Distribution amps for Thub=nderbolt and David
>> partridges divider box?
>>
>> 09/05/2013 11:58
>>
>> If I get a Extron ADA 3-80 distribution amp, will it be able to run on
>> both the 10MHz T/Bolt output, AND on the outputs of one of David
>> Partridge's nice divider boxes I have. It It divides from the 10 MHz
>> input. There are separate outputs for 10 MHz, 5 MHz, 1 MHz, and one
>> that can be configured for 100 kHz / 10 kHz / 1 kHz / 100 Hz / 10 Hz /
>> 1 Hz.
>>
>> If not, is there anything available?
>>
>> Thanks.
>>
>> --
>> Best Regards,
>> Chris Wilson.
>> mailto: chris at chriswilson.tv
>>
> Chris, if I understand your question correctly, the answer is "Yes". The
> ADA-3-80 has four separate channels (R, G, B, Sync), and multiple outputs
> for each channel. So, you can input up to four separate frequencies and get
> up to four outputs for each channel. Quite a versatile little box.
> Cheers,
> Dave M
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
18/05/2013 23:01
I have been offered one of these:
http://www.extron.co.uk/product/product.aspx?id=ada6300mxhv
Specifically the model :
ADA 6 300MX HV HDTV RGBHV 1 x 6 Analog Video Distribution Amplifier
I *THINK* it should meet my needs except the HV bit worries me. It
seems this means it has not got unity gain, but a gain of 0.7 or 1
volt, switch selectable. Could anyone comment if it's suitable to use
my Trimble Thunderbolt with several pieces of test gear at the same
time? Thanks. Here in the UK the ADA-3-80 seems a rare find.
--
Best Regards,
Chris Wilson.
More information about the time-nuts
mailing list