[time-nuts] EG&G RFS-10-7 output selection

[Bob Camp]

Hi

Pretty much all Rb’s want to have a heat sink. Often they got used with some sort of pad rather than heat sink grease. It’s much less messy that way. The rack mount Rb’s are about the only exception to the heat sink rule.

Bob

On Nov 9, 2013, at 12:19 PM, paul swed <paulswedb at gmail.com> wrote:

> Corby
> I have 2 EG&G RBs and would need to look at the model.
> They are putting out 10 Mhz as I recall. Would be happy to look if they are
> the same units to see whatever clues we could get.
> Question I have always had. Do they need to be attached to a heat sink?
> It looks like they may want that yet there is no heat sink compound or any
> clue.
> They look to be quite nice RBs, but at least on the units I have no
> technical info can be found.
> Regards
> Paul
> WB8TSL
> 
> 
> On Fri, Nov 8, 2013 at 3:27 PM, <cdelect at juno.com> wrote:
> 
>> Hi,
>> 
>> I used to have notes on how to select which output frequency the EG&G
>> RFS-10-7 provides but I can't find them!
>> 
>> It can be 5 or 10 Mhz.
>> 
>> Does anybody know where the selection is made?
>> 
>> Thanks,
>> 
>> Corby Dawson
>> 
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.