[time-nuts] My FE-5680A Came In Today
Bob Stewart
bob at evoria.net
Tue Sep 17 20:14:07 EDT 2013
Hi Bob,
Yeah, I figured that retuning it would lose the 1PPS. No biggie. There are a number of those little connectors in this device, and the two that have cables connected use a flat 90 degree connector with a coax that's a bit smaller than RG-174. I just want to snap a pigtail on it and lead it out through a notch in the cover where the DB-9 connector is. There are several examples on the web where people solder wires to the connector and to the RS-232 header. I'd just as soon avoid soldering wires if I can.
Bob
>________________________________
> From: Bob Camp <lists at rtty.us>
>To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
>Sent: Tuesday, September 17, 2013 7:06 PM
>Subject: Re: [time-nuts] My FE-5680A Came In Today
>
>
>Hi
>
>If you retune it, you probably will throw off the pps. The pps drive strength is a bit weak, so you need to be careful looking for it. On some units there is a software command to enable / disable it (as in pps only when warmed up and locked - like a gps). The can / cover on the unit is mu metal (Rb's are mag sensitive). If you drill a hole in it, you are likely to impact it's mag shielding properties.
>
>Bob
>
>
>On Sep 17, 2013, at 6:21 PM, Bob Stewart <bob at evoria.net> wrote:
>
>> My FE-5680A Rb standard came in today. After the usual inspections etc, I fired it up and I have the purple haze. The native output is 8.38860798/9 (last digit jitter) as read on my 5335A using my GPSDO as an external standard. I've got a ways to go before it's all setup, but this is looking good. Does it warmup and change frequency at all, or can I retune it to 10MHz and use it as a reference without any further ado?
>>
>> Can someone tell me what type of socket that is where you tap off the RF? It looks sort of like a uFL connector, but a bit bigger. I'd rather avoid hacking and soldering on this if I can.
>>
>> Bob - AE6RV
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
>_______________________________________________
>time-nuts mailing list -- time-nuts at febo.com
>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>and follow the instructions there.
>
>
>
More information about the time-nuts
mailing list