[time-nuts] Lucent KS-24361 RS-422 interface pinout
planophore at aei.ca
planophore at aei.ca
Wed Dec 3 07:28:00 EST 2014
Good morning Anthony,
Yes, I did see your posting. Thank you for your help.
cheers, Graham ve3gtc
On 12/3/2014, "Anthony Roby" <aroby at antamy.com> wrote:
>I sent you my posting earlier today, so hopefully you saw it. The Lucent unit seems liberal in its interpretation of the pinouts, but once you've deciphered it and got the +ve and -ve pins connected, it works reliably.
>
>Anthony
>
>-----Original Message-----
>From: time-nuts [mailto:time-nuts-bounces at febo.com] On Behalf Of Graham
>Sent: Tuesday, December 02, 2014 5:36 PM
>To: time-nuts at febo.com
>Subject: Re: [time-nuts] Lucent KS-24361 RS-422 interface pinout
>
>Thanks all for answering my question. I looked through old posting but obviously didn't stumble upon Anthony's posting otherwise I would have had my answer.
>
>I made up a short cable to connect the Startech ICUSB422 to the KS-24361
>J8 Diagnostic port and I can now connect. This is the final pinout:
>
>Startech KS-24361
>ICUSB422 J8 - Diagnostic
>=========================================
> 1 TXD- --------------> RXD- 8
> 2 TXD+ --------------> RXD+ 4
> 3 RXD+ <-------------- TXD+ 5
> 4 RXD- <-------------- TXD- 9
> 5 GND --------------- GND 7
> 6 NC
> 7 NC
> 8 NC
> 9 NC
>
>Seems RS-422 is a standard but pinouts vary. Live and learn.
>
>cheers, Graham ve3gtc
>
>
>
>On 2014-12-01 21:10, Bob Camp wrote:
>> Hi
>>
>> If you dig back a month or so, there is a post with all the pinouts on all the connectors.
>>
>> 4 RX+
>> 8 RX-
>>
>> 5 TX+
>> 6 TX-
>>
>> 3 and 7 ground
>>
>> It ??s serial so TX on one goes to RX on the other. + goes to + and - to - The pins are numbered on the connector in *very* small print.
>>
>> Bob
>>
>>
>>
>
>_______________________________________________
>time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>and follow the instructions there.
>_______________________________________________
>time-nuts mailing list -- time-nuts at febo.com
>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>and follow the instructions there.
>
>
More information about the time-nuts
mailing list