[time-nuts] PRS-45 Cs Standard

[Magnus Danielson]

Bob,

Do open up and take a look. Do take photos. Do share. :)

Bet the bottom plate is a good start.

Cheers,
Magnus

On 12/05/2014 10:31 PM, Bob Stewart wrote:
> Hi Magnus,
> It came in today.  Looks good from the outside.  No obviously bad smells, but I can't power it up, as my PSU hasn't come in yet.
>
> There is a paper Datum tag dated 6/2/03 on the outside.  Looking through the vent holes, I can see a Datum Cesium Beam Tube assembly Model Number 7613A/077, Part Number 74514-110.  I can see that the back two panels have been removed and replaced, but nothing obvious has been done on the inside.  There are two SMB connectors on the main board that don't have anything plugged in, but there's nothing obvious that they'd connect to.  Does any of that tell me something that I don't want to know?  It's going to be a long wait till Monday.  =)
>
> Bob
>
>        From: Magnus Danielson <magnus at rubidium.dyndns.org>
>   To: time-nuts at febo.com
> Cc: magnus at rubidium.se
>   Sent: Wednesday, December 3, 2014 1:38 PM
>   Subject: Re: [time-nuts] PRS-45 Cs Standard
>
> Hi Bob,
>
> The manual is in your inbox.
> It also describes a DS1 interface, which should be interesting to know
> what the odd telecom signals is about. :)
>
> Cheers,
> Magnus
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>