[time-nuts] LNA and Alias
bruce.griffiths at xtra.co.nz
Mon Dec 22 02:23:42 EST 2014
Are you sure that the setup is aligned to minimise AM response?
Are you using cross-correlation?
On Monday, 22 December 2014 5:08 PM, Loïc Moreau <loic.moreau at eai..fr> wrote:
My phase noise measurements system give erroneous results in close in phase noise measurements, I got humps in the 1Hz-1000Hz area as high à 20 dB more than expected.
The setup is using a mixer to compare reference and DUT witch drive an LNA http://www.ko4bb.com/~bruce/LowNoiseMixerPreamp.html , the output is driving an AD7760 ADC and an op amp circuity is connected to the VFC reference to achieve quadrature. The results are analyzed with an homebrew FFT charting software
After struggling with different configurations, switched different LNA, ADC , sound card. A scope connected to the LNA output indicate steady 20MHz residuals just before the ADC ( around 10 mv peak-peak).
In fact , it seems that the mixer 20Mhz residuals ( DUT + REF ) are entering the ADC and so theses alias give erroneous results in the 1Hz-100Hz area, displaying unexpected artifacts. In order to fix the problem I will probably include an analog filter just before the ADC input (same as LNA input 1nF 80µH), but I want to know if some more sophisticated measures should be undertaken as an 5th Order Lowpass Filter.
I have not found many clue about alias problems in phase noise measurements literature so I may have missed something ?
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts