[time-nuts] Another Arduino GPSDO

Eric Williams wd6cmu at gmail.com
Fri Mar 28 21:56:09 EDT 2014

Right, I should be able to get that from the TIM-TP message, but then what
do I do with it?  Not sure how I can apply a picosecond correction in this
configuration short of adding a programmable delay line chip that would
cost more than the GPS receiver did.

On Fri, Mar 28, 2014 at 6:40 PM, Chris Albertson
<albertson.chris at gmail.com>wrote:

> On Fri, Mar 28, 2014 at 5:15 PM, Eric Williams <wd6cmu at gmail.com> wrote:
> > OK, now I understand the reference, but not the significance in this
> > context.  The sawtooth error is below the resolution of the counter here.
> I think you are right.  It hardly matters for your application.  I think
> you said this was going to drive a wall clock?
> But on the other hand using sawtooth is free and does not add to the parts
> count.  All you do is read some serial data.
> --
> Chris Albertson
> Redondo Beach, California
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.

More information about the time-nuts mailing list