[time-nuts] Divide by five

[Said Jackson]

Joe,

This puppy can go to 166MHz over temp and has standard 100 mil pin spacing if you put it into a socket: ATF16V8C

I have not used PALs since 1992 but I used to be extremely fond of the 16R8 and 22V10 types back then.

This is a 16V8 that will do your divider in no time:

http://www.digikey.com/product-detail/en/ATF16V8C-5JX/ATF16V8C-5JX-ND/1027054

Best of all its available and only ~$3..

Said

Sent From iPhone

> On Nov 7, 2014, at 19:37, Joseph Gray <jgray at zianet.com> wrote:
> 
> Looks like I can get the 74AC161 in DIP from Mouser. Thanks to everyone for
> the suggestions. I still like DIP for prototyping on breadboards.
> 
> Joe Gray
> W5JG
> 
> 
>> On Fri, Nov 7, 2014 at 4:45 PM, Alex Pummer <alex at pcscons.com> wrote:
>> 
>> 
>> 
>> check if you could get a 74AC161, which could be connected  to divide by 5
>> at 125 MHz see here http://ecee.colorado.edu/~mcleod/pdfs/IADE/references/
>> 74AC161.pdf to be sure to work at 125MHz run with 5,5 to 6V...
>> 
>> 73
>> Alex
>> 
>> 
>> 
>>> On 11/7/2014 1:12 PM, Joseph Gray wrote:
>>> 
>>> I need to divide a 125 Mhz clock by five. I have looked on Mouser and
>>> every
>>> chip I find is either obsolete or in SMT. Can anyone recommend a chip that
>>> is fast enough and comes in DIP?
>>> 
>>> Joe Gray
>>> W5JG
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to https://www.febo.com/cgi-bin/
>>> mailman/listinfo/time-nuts
>>> and follow the instructions there.
>> 
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/
>> mailman/listinfo/time-nuts
>> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.