[time-nuts] KS-24361 15 pin interface quick solution

[Bob Camp]

Hi

I toss my DC load resistors on an un-used port on the splitter. That way they really don’ mess anything up. I don’t bother with a coil, but I also don’t bother with short leads.

Bob

> On Nov 9, 2014, at 8:33 PM, paul swed <paulswedb at gmail.com> wrote:
> 
> Turns out the Interface J5 perfectly accepts .1 inch spaced pins.
> You may have these laying around. I simply snipped off 2 sets of 3 pins.
> Placing them in  J5 1-3 and J5 6-8. The additional pins make it very stable.
> Then solder ground from pin 8 to 3 and 470 ohm chip resistor from 3 to 2.
> Thats it. Very stable with parts from the drawer.
> 
> Regards
> Paul
> WB8TSL
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.